Lighting & Fountain Guides

Retrofitting Old Facade Lighting: What to Replace, What to Keep

Phối cảnh ý tưởng Facade Signature: LED Pixel tạo hiệu ứng sóng trên mặt dựng

Many hotels and buildings installed facade lighting years ago. Over time, fixtures fail one by one, colours no longer match, electricity bills rise and the image looks dated. A well-planned retrofit makes the building look good again without starting from scratch.

Signs it is time to retrofit

  • Many fixtures are off or flickering, leaving the facade patchy.
  • Light colour is uneven after replacing fixtures one at a time.
  • Halogen or metal halide floodlights are still in use, which are power-hungry and hot.
  • Brackets, fixings and junction boxes are rusting, especially near the sea.
  • The system can only switch on and off, with no scenes or timers.

Assess before you decide

A thorough survey shows what can be reused:

  1. Mounting positions and brackets: if they are sound and in the right places, keep them to save cost.
  2. Cables and conduits: check cable size, insulation and waterproofing.
  3. Power and panels: LEDs need suitable drivers. Old panels may need new protection devices.
  4. Signal lines: colour-changing fixtures need control cables to every group.
  5. Access: establish whether scaffolding, lifts or a gondola are needed to cost the work.

Common retrofit options

Swap to LED, keep the layout

The fastest and most economical option. The image stays the same but the light is more even and uses less energy.

Upgrade to RGBW colour change

Adds scene changes for holidays and events. Requires a controller and signal cabling.

Redesign part of the facade

Keep what still works and redesign the key areas, such as the street-facing facade or logo. Suits owners who want a fresh image on a moderate budget.

Concept rendering of Dynamic facade lighting with blue and purple bands
Concept rendering: upgrading to RGBW light that changes colour by zone.

Retrofitting in phases

Everything does not have to happen at once. Start with the main facade and logo, then do the other elevations later. The key is to agree on the control system and lighting tone from the start so later phases match.

How ARTTEC works

ARTTEC surveys the existing installation and builds a 3D simulation of the options for you to compare and approve, before moving to design, contract and installation. The person who surveys with you stays with the project until handover. For occupied buildings, the schedule is agreed to minimise disruption to guests and staff.

See also hotel facade lighting retrofit budgets, our architectural lighting solutions and the indicative budgets.

Frequently asked questions

Does switching to LED require rewiring?

Not always. If the cables are in good condition and large enough, they can be reused. Moving to colour-changing fixtures does require additional signal cabling.

Can old fixtures that still work be kept?

Possibly, if their colour and brightness match the new fixtures. It is usually better to replace each elevation as a set to avoid colour mismatch.

Does your building already have old facade lighting? Send day and night photos via Zalo +84 935 004 188 and ARTTEC will assess the retrofit options.

Leave a Reply

Your email address will not be published. Required fields are marked *