Lighting & Fountain Guides

LED Facade Lighting Repair in Da Nang, Hue and Hoi An

Phối cảnh ý tưởng Facade Signature: LED Pixel tạo hiệu ứng sóng trên mặt dựng

Is your hotel or building facade dark in sections, flickering or showing a different colour on every fixture? This is very common on coastal buildings in Central Vietnam after a few rainy seasons. The good news is that most cases do not need a full replacement. This article helps you identify the cause from the symptom, decide whether to repair or replace, and know what to send for a fast quotation.

ARTTEC repairs facade, building, landscape and fountain lighting systems. We do not repair individual indoor lamps.

LED lights keep flickering

Common causes: a weak or failing power supply, an overloaded supply after extra fixtures were added, voltage drop on long cable runs, or poor contact at damp connectors.

Fix: measure voltage at the supply and at the end of the run, replace failed supplies and rebalance the load. On long runs, switching to 48 V stops the last fixtures flickering or dimming. See 48 V LED.

A section of lights is dark

Common causes: water in a connector, one failed fixture breaking the signal to everything after it, or cables damaged by rodents or other building works.

Fix: find the first dark point and check the connector and fixture there. Replace the connector with a waterproof one and the failed fixture with the same model to avoid colour mismatch.

Uneven brightness or mismatched colours

Common causes: replacement fixtures from a different production batch, older LEDs ageing unevenly, or a supply too small for the whole run.

Fix: replace by group rather than one fixture at a time, use fixtures from the same batch and recalibrate colour in the controller. For new installations, keep spare fixtures from the same batch.

Colour effects stutter, show wrong colours or will not change

Common causes: signal interference, data cables run alongside power cables, a missing termination resistor, a failed controller or lost scenes. Many buildings also find that the original installer is far away and nobody knows how to change the colours.

Fix: check the signal path, replace the controller and rebuild the scenes. Upgrading to a 4G remote controller means holiday colour changes no longer need anyone on site. See 4G controllers.

Rusty fixtures and brackets, water inside

Common causes: 201 stainless or galvanised screws, housings not rated for salt air, rubber seals hardened by the sun.

Fix: replace screws and brackets with 316 stainless steel, renew seals, and replace fixtures that have taken in water with marine-rated ones.

Repair or replace?

ConditionRecommendation
Fewer than about one third of fixtures failed, model still availableRepair: replace supplies, connectors and failed fixtures
Fixtures fine but controller failed, colours cannot be changedKeep fixtures, replace the controller
Many failures, rusted housings, widespread water ingressReplace by zone, starting with the main facade
Old model discontinued, severe colour mismatchReplace the whole facade or whole groups for uniformity

ARTTEC surveys at night before quoting, so only what really needs replacing is replaced. For a full upgrade, see facade lighting retrofit.

What to send for a fast quotation

  • A night photo of the whole facade showing the dark or mismatched sections.
  • A 30-second video if the lights run effects.
  • Photos of the control cabinet and power supply labels, if accessible.
  • Building address and number of floors.

Note: do not climb the facade to inspect it yourself. This requires proper equipment and people certified for work at height.

Scheduled maintenance so lights do not fail in peak season

On coastal buildings, inspect the system at least twice a year, once before the rainy season. ARTTEC offers annual maintenance contracts covering:

  • Inspection of fixtures, supplies, control cabinet, connectors and brackets.
  • Cleaning lenses, renewing seals, retightening screws in wind-exposed positions.
  • Replacing failed fixtures with spares from the same batch.
  • Changing colour scenes for major holidays during the year.

Service area

ARTTEC is based in Da Nang and repairs LED facade, building and landscape lighting in Da Nang (Son Tra, Ngu Hanh Son, Hai Chau, Hoa Xuan), Hoi An, Hue, Quy Nhon and Lang Co. We can repair systems installed by other contractors, even without original documents. If you are planning a new installation, see LED facade lighting installation.

Frequently asked questions

Can ARTTEC repair a system installed by another company?

Yes. We survey the site, redraw the wiring diagram and equipment list. If the original fixtures are discontinued, we propose equivalents with matching colour and size.

Can colour-changing lights be repaired while the hotel stays open?

Yes. Most inspection and replacement work is done during the day, with testing in the evening, without disturbing guests.

Facade dark in sections or flickering? Send a night photo via Zalo +84 935 004 188 and ARTTEC will give an initial assessment and arrange a site survey.

Leave a Reply

Your email address will not be published. Required fields are marked *