Lighting & Fountain Guides

Optimising Outdoor Facade Luminaires: 6 Points to Check

Phối cảnh ý tưởng Facade Lite: Chiếu sáng vàng ấm nhấn đường nét khách sạn

Two fixtures that look alike in a catalogue can last years apart once installed outdoors. Leading architectural lighting manufacturers in China, where thousands of large facade lighting projects have been built, focus their improvements on the six points below. These are also what ARTTEC checks when selecting equipment for a project.

1. Heat dissipation

Heat is the main reason LEDs lose brightness and shift colour early. Good fixtures have die-cast or thick extruded aluminium bodies with well-designed fins, and some use ceramic substrates with excellent thermal conductivity. When comparing, ask for the operating temperature at full power, not just the wattage.

2. Waterproofing and condensation

  • Protection rating: outdoor fixtures should be IP66 or higher. In-ground fixtures or those that may be flooded should be IP67 or IP68.
  • Potting or gaskets: fully potted fixtures are very well sealed but hard to repair. A good gasketed design is easier to maintain. Each suits different positions.
  • Breather valves: day-night temperature swings make fixtures “breathe in” moisture. A pressure-equalising valve limits condensation inside the lens.
  • Cable entries: waterproof connectors, with cables routed downwards so water does not run along them into the fixture.

3. Corrosion resistance near the coast

For projects in Da Nang, Hoi An and other coastal cities, this is the most overlooked point:

  • Powder-coated housings that pass salt spray testing.
  • Grade 316 stainless steel fixings and brackets.
  • No direct contact between dissimilar metals in humid, salty conditions, which causes galvanic corrosion.

4. Optics and glare control

Good light comes from the right lens, not from more watts. Modern fixtures offer many beam angles, from very narrow beams of a few degrees for tall columns to wide beams for wall washing, plus asymmetric lenses to cover a wall evenly from close to its base. Honeycomb louvres or shields reduce glare into rooms and onto passers-by.

5. Replaceable drivers

Drivers usually fail before the LEDs. A separate driver compartment, or central drivers in a technical cabinet, allows the driver to be replaced without replacing the whole fixture. Combined with a 48 V LED system, the number of drivers on the facade drops significantly.

6. Surge protection

Fixtures on roofs and high facades are exposed to lightning surges travelling along cables. Surge protection is needed at the panel, at the drivers and on the control signal lines, together with a compliant earthing system.

Ask suppliers for evidence

Rather than relying on the catalogue alone, ask for:

  • IP and salt spray test reports.
  • Lumen maintenance data for the LEDs.
  • A clear warranty for fixtures and drivers.
  • Samples installed on site before ordering in volume.

See also our architectural lighting solutions and solutions for new and existing buildings.

Frequently asked questions

Can IP65 fixtures be used outdoors?

Yes, in sheltered positions with little direct rain. Facades exposed to wind and rain, especially near the sea, should use IP66 or higher.

Why do new fixtures fog up after a few months?

Usually because of gaskets, cable entries or the lack of a breather valve. Moisture gets in as the fixture cools at night, then condenses when the sun heats it.

Need an assessment of equipment for your project? Send the fixture schedule or site photos via Zalo +84 935 004 188.

Leave a Reply

Your email address will not be published. Required fields are marked *